All the adze including the new Kirschen tools are sharpened by me before leaving the workshop. I take a lot of time and care preparing and making sure that your adze is ready for work. If you have any questions do not hesitate to contact me either by phone or email.

0411 256926


  • Hytest Adze



    This old adze is one of the best I have had go through my workshop for a while. I doubt very much if it has done much work at...

  • Hytest Plumb Australia Adze


    A fantastic example and ready for work this old adze is just over 30cm from the hammer to the 10cm cutting edge. Below is ...

  • Brades Adze - Partial Sticker


    This one is a rare example and all but as it was found. Not often you find one that still has the remains of the original sti...

  • Robert Sorby Sheffield No 4


    Looking for a good adze that can be put straight back to work? Then this one has plenty of life left in it, is sharp and read...

  • Kirchen Hollow Edge Adze


    New adze made in Germany 70mm cutting edge. Designed for making round and curved cuts and roughly hollowing timber. I also ha...

  • Kirchen Adze


    New adze made in Germany 85mm cutting edge. I also have handles in either ash or spotted gum.